# Cabling and PoE Planner | KINNEX

> Place data outlets, access points, cameras, phones and comms racks on your own floor plan, and get cable lengths, switches and PoE per rack, with a schedule.

Source: https://kinnex.in/tools/cabling-poe-planner/

---

[Tools](https://kinnex.in/tools/)

Planning tool

# Cabling and PoE planner

Upload a floor plan (PDF, DXF, DWG or image), set its scale, and place every outlet, access point, camera and comms rack. The planner works out each cable run, the cable to order, the switches and the PoE load for each rack.

Loading the planner…

Method

## How the planner works out the cabling

### Cable runs

Each outlet goes to its nearest comms rack (or the one you choose). The run is the distance along the plan's x and y directions, the way cable follows walls and trays, plus the drop from the ceiling tray to the outlet, the rise at the rack, and the slack you set for each end.

### Racks

For each rack: outlets, ports with spare, switches of the size you choose, the PoE load of its devices plus 10%, the longest run, and the total cable.

### Limits to watch

-   A copper permanent link is at most 90 m. Runs over it are drawn in red and listed.
-   PoE draws are typical values per device type. Use the data sheets, and the[PoE budget calculator](https://kinnex.in/tools/poe-budget-calculator/) for cameras with infrared and PTZ.

### Then

Turn the totals into an order with the[bill of quantities builder](https://kinnex.in/tools/bom-builder/), and check the rack with the [rack elevation planner](https://kinnex.in/tools/rack-elevation-planner/).

Your plan is saved in this browser only. Nothing is uploaded to KINNEX unless you choose to send it to us.
